Lifebar 3, 5, 10, 13,000

Connect to this rapid-charging, high capacity portable battery charger, and give your devices the power they need.

How do I use the lifebar?
Make sure that the Lifebar is fully charge. Next connect the plug in the USB cable to the lifebar. Check your device if it is charging, if it i...
Tue, Jan 6, 2015 at 3:14 PM
What if the Lifebar fails to recharge?
a. Check that the adapter is connected securely, or replace it if the current one is not functioning normally. b. Check that the USB cable is connected ...
Tue, Dec 16, 2014 at 4:19 PM
Can the lifebar be charged and charge other devices at the same time?
Constant AC to Lifebar to Device charging will affect the Lifebar's lifespan and shorten it. HIGHLY not recommended, however it is possible by clicking...
Wed, May 27, 2015 at 5:13 PM
How do I know if the lifebar charging?
The percentage indicators will light up you'll be able to tell which percentage it's at when charging because that light will flash on and off.
Tue, Dec 16, 2014 at 4:22 PM
Is the lifebar compatible with my item?
The output on the Lifebar is DC5V / 2A majority of hand held products will work. Check that the Lifebars voltage is compatible with your electronic device&#...
Tue, Dec 16, 2014 at 4:19 PM
How long does the lifebar take, to be fully charge?
For the Lifebar 10 it can take up to 10 hours or over night for a full charge with a 1A output charger For the Lifebar 5 it can take up to 5-6 hours ...
Tue, Jan 6, 2015 at 3:18 PM
What's the discharge rate without using the lifebar?
For the Lifebar 3 Standby Time : 288hrs For the Lifebar 5 Standby Time : 400hrs For the Lifebar 10 Standby Time : 800hrs
Tue, Dec 16, 2014 at 4:21 PM
How to check how much battery percentage the lifebar has?
There's a little button and 4 LED lights. They are located on the side of the lifebar, right next to where you plug in the USB cable. If you press the ...
Mon, Jan 5, 2015 at 9:49 AM
How do I turn off the blue lights? (percentage indicators)
Hold the button down next to the percentage indicators.
Tue, Dec 16, 2014 at 4:25 PM
How do I turn on the flash light? (Only applicable to Lifebar 10)
Double click the button next to the percentage indicators and the light should turn on. To turn off, double click again.
Tue, Dec 16, 2014 at 4:26 PM